FOSROC NITOSEAL MS100 L/GREY 600ml

Fosroc Conbextra GP Grout is a high-flow, nonshrink cementitious grout, conforming to the requirements of BS EN 1504-3 Class R4 and BS EN 1504-6: Anchoring of a reinforcing steel bar.

Used for grouting gap thicknesses 10 to 75mm.

Unit Size: 25kg

(FOR FOILED PRODUCTS - SAUSAGES)

Fosroc Lokfix E35S is a two component polyester anchoring material, supplied in single component cartridges with a static mixer nozzle.
When applied it sets and cures rapidly to firmly secure a variety of steel fixings into concrete and masonry substrates.

Unit Size: 300ml

Fosroc Lokfix E55S is a two component vinyl-ester anchoring material, supplied in single component cartridges with a static mixer nozzle.
When applied it sets and cures rapidly to firmly secure a variety of steel fixings into concrete and masonry substrates.

Unit Size: 300ml

Applicator gun for Lokfix E75 Unit Size: Each

Fosroc Lokfix E77 is a two-component epoxy anchoring material, supplied in 3:1 ratio side-by-side cartridges with a static mixer nozzle. When applied it sets and cures to firmly secure a variety of steel fixings into concrete and solid masonry substrates. Unit Size: 385ml

Fosroc Lokfix S25 is a two component polyester anchoring grout supplied in pre-measured quantities.

The material cures quickly to give consistent, high performance anchorages.

It is a pourable grade, with a 25 minute gel time at 20°c for use in vertical down holes where the hole is 8 to 40mm greater in diameter than the bar.


Unit Size: 2.5ltr

Fosroc Nitoseal MS300 is a one part, high modulus sealant based on hybrid silyl modified polyether technology.
It has a rapid rate of cure and forms a tough elastomer capable of supporting heavy wheel loads.
It may be applied between 6mm and 20mm wide, for internal trafficked flush joints and up to 40mm wide, for non-tracked/recessed tracked joints.

Unit Size: 600ml

Fosroc Nitoseal MS60 is a one part, low modulus sealant based on hybrid silyl modified polyether technology.
It is suitable for sealing joints in concrete, brickwork, blockwork, perimeter sealing around doors and windows, and non-trafficked floor joints.

Unit Size: 380ml

Fosroc Mulseal DP is a single part bitumen latex emulsion, applied by brush or squeegee.
The incorporation of rubber latex imparts elasticity to the dried coating.
Mulseal DP is suitable for use on most building materials such as concrete, brickwork, metals and stone.

Unit Size: 25ltr