An extra-quick setting liquid waterproofing admixture that causes almost immediate setting and very rapid hardening of Ordinary Portland Cement.
Unit Size: 5ltr
Sika 4 Rapid Setting is used to aid the quick setting of cement based renders and concretes where low water pressure or slow moving water exists.
Unit Size: 5 ltr
A rapid setting waterproofing admixture, which when mixed with ordinary Portland cement and water, sets rapidly to seal areas of severe water infiltration through concrete, rock or masonry.
Unit Size: 5ltr
The Sika Bentoshield Fixing Nose Piece is designed to support the washer on the end of the gun and hold it in place for safe and correct fixing of the Sika Bentoshield membrane system.
Unit Size:
Sika Bentoshield Granules are polymer modified natural sodium bentonite granules, when wetted these granules form a dense waterproof paste.
Unit Size: 25kg
A self healing waterproofing membrane that is resistant to contaminated soils, forming an automatic mechanical bond to freshly poured concrete.
Unit Size: 1.1m x 5m rolls
A single component mastic consisting of polymer modified natural sodium bentonite and further polymer additives. Trowel applied and thixotropic in nature.
Unit Size: 15ltr
A post applied self-adhesive waterproofing sheet membrane. It is based on a top layer of polyethylene film bonded to a layer of bitumen/polymer adhesive carried on a release paper, with a selvedge strip.
Unit Size: 1.05m x 19.05m
A blend of high-grade silicates and wetting agents, held in suspension with water as a carrier. Once applied to the concrete surface, this unique product seals the concrete surface.
Unit Size: 25kg
The Sika Cavity Drainage System Corner Piece is installed at the corners of a perimeter drainage channel system to allow continuity of the drainage system.
The Sika Cavity Drainage System Channel T Piece is installed at the junction between wall and cross channel drainage system to allow continuity of the drainage system.
A 150mm wide tape which has many uses but is mostly used to seal membrane from walls to floors and the channel system.
Tacky on one side only, this can also be used to overtape external joints and used on floor oversealing.
Unit Size: 150mm x 20m
A 10mm bead of butyl rope, which is used to either wrap around the head of plugs in membrane installation, or to form a jointing waterproof seal on walls and floor membrane systems.
Unit Size: 10mm wide x 5m long
A PVC drainage conduit for the control of water ingress in below ground waterproofing situations.
It has a flange upstand and is fitted around the perimeter of the floor at the vulnerable wall to floor junction, directly any ingress of water towards a sump chamber or drain.
Unit Size: each
A drainage outlet that can be used to get water from the channels to the sump chamber or existing drain. The angle bend on the underside of the channel takes water through a 32mm connection.
A flexible waterproofing tape based on modified flexible Polyolefin (FPO) with advanced adhesion properties.
It has red masking tape on one side for easier application over expansion joits.
Unit Size: 1 roll of 25m length
Varying widths available: 10, 20, 30cm