Manufacturer:

PAREX THIXOTROPIC JOINT FILLER 25kg

A pumped mortar purpose-designed for filling joints and gaps in precast concrete units without the need for formwork. Unit Size: 25kg bag

Availability: 325 in stock

Depot Stock

Bury St Edmunds Depot	Out of stock
Kent Depot	Out of stock
Midlands Depot	Out of stock
Sheffield Depot	Out of stock
West London Depot	325 in stock

£14.99 excl tax

Sold in units of: BAG

Qty:

i h

Overview
Specifications
Product Disclaimer
Downloads
Contact Us

Uses:
◇ Structural support between and beneath precast concrete elements.
◇ Permanent in situ shuttering in joints between precast concrete elements which will be post-grouted.
◇ Rapid placement using m-tec Duo-Mix mixer-pump systems.
◇ The material can be used for placing in horizontal and vertical gaps of 5mm to 100mm where a cementitious mortar infill is required and flow grouting is inappropriate.
◇ Parex Thixotropic Joint Filler (TJF) is chloride-free and can be safely used in contact with steel reinforcement.

Advantages:
◇ Easily mixed and applied.
◇ Chloride-free.
◇ Wide application range (gaps 5 to 100mm).
◇ Shrinkage compensated.
◇ High strength.
◇ Thixotropic
◇ Low sag nature
◇ Reaction to Fire: EuroClass A1.

Products specifications

Shelf Life	6 Months. Store properly in dry conditions in undamaged and unopened original sealed packaging.
Appearance	Grey powder.
Coverage	Each 25kg bag will yield approximately 13.5 litres of mixed material.

The product image(s) shown are for illustration purposes only and may not be an exact representation of the product.

The recommendations relating to the application and end-use of the products mentioned are based on our current knowledge and experience of the products when properly stored, handled and applied under normal conditions. All product specification, information and data made available on the website is subject to change. All information presented is believed to be accurate and reliable, but is given without guarantee, warranty or responsibility of any kind.

Technical Datasheet

Your name *

Your email *

Subject: *

Enquiry *

Products from the Same Manufacturer

PAREX 100 NEWTON GROUT 25kg

A one-part, early ultra high strength grout with special shrinkage compensating components, which give a non-shrink grout in both the plastic and harden states. Unit Size: 25kg

Stock Status: 682 in stock

£21.83 excl tax

Sika 1 Liquid Waterproofing Product Image

SIKA 1 LIQUID WATERPROOFING 25L

A normal setting liquid waterproofing admixture for mortar and concrete. Unit Sizes: 25 ltr

Stock Status: 1 in stock

£188.26 excl tax

SIKA 1 LIQUID WATERPROOFING 5L

A normal setting liquid waterproofing admixture for mortar and concrete. Unit Sizes: 5ltr and 25 ltr

Stock Status: 24 in stock

£57.13 excl tax

SIKA 2 WATER STOP 5LTR

An extra-quick setting liquid waterproofing admixture that causes almost immediate setting and very rapid hardening of Ordinary Portland Cement. Unit Size: 5ltr

Stock Status: 57 in stock

£40.41 excl tax

SIKA 4 QUICK SETTING LIQUID 5LTR

Sika 4 Rapid Setting is used to aid the quick setting of cement based renders and concretes where low water pressure or slow moving water exists. Unit Size: 5 ltr

Stock Status: 19 in stock

£57.40 excl tax

SIKA 4A WATERSTOP LIQUID (5)

A rapid setting waterproofing admixture, which when mixed with ordinary Portland cement and water, sets rapidly to seal areas of severe water infiltration through concrete, rock or masonry. Unit Size: 5ltr

Stock Status: 448 in stock

£36.83 excl tax

SikaTop Armatec 110 EpoCem 20kg product image

SIKA ARMATEC 110 EPOCEM 20kg (3 PART PRODUCT)

A cementitious epoxy resin compensated 3-component coating material with corrosion inhibitor, used as bonding primer and reinforcement corrosion protection. Unit Size: 20kg (A=1.14kg, B=2.86kg, C=16kg)

Stock Status: Out of stock

£384.01 excl tax

SIKA ARMOREX L2 HIGH FLOW 25kg

A one part, high flow, rapid strength cementitious grout. Unit Size: 25kg bag

Stock Status: 287 in stock

£18.64 excl tax

SIKA BENTOSHIELD FIXING NOSE PIECE

The Sika Bentoshield Fixing Nose Piece is designed to support the washer on the end of the gun and hold it in place for safe and correct fixing of the Sika Bentoshield membrane system. Unit Size:

Stock Status: 1 in stock

£332.57 excl tax

SIKA BENTOSHIELD FIXING WASHERS 700 per bag

Sika Bentoshield fixing washers are special plastic washers used to fix Sika Bentoshield membrane to vertical surfaces and horizontal laps. Unit Size:

Stock Status: 5 in stock

£249.46 excl tax

PAREX THIXOTROPIC JOINT FILLER 25kg

Payment options