Waterproofing

A two-pack solvent free black liquid modified epoxide surface conditioner that can be applied to damp surfaces. Unit Size: 5ltr or 15 ltr (2-part)

A high density polyethylene (HDPE), heavy duty drainage and protection sheet with 10mm high dimples on the bottom layer and a bonded geotextile (PP) filtration layer on the top layer. Unit Size: 2,44m width x 12,50m length

.

GCP Serviseal AT 240 is an important advance in concrete joint protection which combines Active Technology with the conventional mechancial properties of PVC waterstops, developed for water exclusing and retaining structures such as basements, reservoirs, sewage treatment works etc. Unit Size: 7.5 m long coil

A two component system both supplied in the same tin. The first component (Part A) is a bitumen-extended polyurethane fluid (15kg). The second component (Part B) is an accelerator hardener (0.6kg). Unit Size: 15.6kg

Triton Platon P20 Cavity Drain is a high capacity drainage membrane recommended for use on all floor applications below ground due to its ability to control free flowing water. Unit Size: 2m x 20m x 20mm roll

A crystalline waterproofing admixture powder consisting of a blend of specially selected chemicals. When combined with ready mix concrete at batching plant, it produces a crystalline reaction which enhances water resistance and durability of the cured concrete. Unit Size: A tub consisting of six 4.1 kg soluble bags and used in the ratio of 1:1 i.e. one 4.1kg bag for each 1m³ of concrete.

JUTA GP Titanbond Edge Strip is a specially designed narrow width roll of the GP Titanbond for use on kicker details, or transitions areas from horizontal to vertical. Unit Size: 1m x 25m

A galvanised metal sheet with a special coating applied on one side to increase its adhesion to fresh concrete Unit Size: 15m rolls

Minova CarboStop 102 is a water-reactive, CFC and solvent free, one-component polyurethane resin.

It is an easy to use way of stopping water inflow under high pressure.

Unit Size: Kit - consists of part A (102 20kg tin) & B (102 Acc 1kg tin)

An economical low capacity, low friction bearing strip which can be used under in-situ or precast concrete slabs and beams, structural steelwork bearing plates and pipe support to form a thin sliding joint.

Unit Size: Roll

A 1.0mm thick high density polyethylene (HDPE) profiled sheet with approximate 20 mm high studs . Unit Size: 2m x 20m roll

A flexible waterproofing tape based on modified flexible Polyolefin (FPO) with advanced adhesion properties. It has red masking tape on one side for easier application over expansion joits. Unit Size: 1 roll of 25m length Varying widths available: 10, 20, 30cm

A two component, solvent free, highly elastic, low odour polyurea hybrid waterproofing membrane. Unit Size: 25kg (Part A= 9.2kg, Part B=15.8kg)

GCP Betec Mesh is a reinforcing mesh for use where substreate cracking has or is likely to occur.

RIW Cavity Drain R7 is manufactured from 0.5mm translucent virgin high density polyethylene with studs approximately 8mm high. Unit Size: 2m wide x 20m long

Cetco Aquadrain ICD 20mm is the highest drainage capacity membrane in the Aquadrain ICD range giving a void volume of 14 litres/m². Unit Size: 2.0m x 20m* *including flat overlapping edge (flange) without studs, working area ca. 40m²

Hyload Gastite is a cold applied self-adhesive membrane protecting structures against the ingress of moisture and methane radon gasses.

Unit Size: 1m x 20m rolls

Masterlife WP 754 is a pre-applied sheet membrane waterproofing system consisting of highly flexible polyolefin membrane and a designed non-woven fleece. Unit Size: 1.6MM X 1.0M X 20M

Masterlife WP 754 is a post-applied sheet membrane waterproofing system consisting of a highly flexible polyolefin membrane with self adhesive backing. Unit Size: 1m x 20m

A geocomposite drainage sheet with a 8mm thick HDPE cuspated core and non-woven polypropylene geotextiles, recommended for most building and civil engineering drainage applications. Unit Size: 2.4m x 20m roll

Drainage and protection cavity membrane used externally against retaining walls and across terraces and podiums. Unit Size: 2m x 15m x 7mm roll

Visqueen High Performance Urban Drainage Geomembrane is a robust thermoplastic geomembrane, black in colour, 1mm thick and supplied in single wound rolls (not folded). Unit Size: 1.4m x 50m

A flexible 0.6mm composite damp proof course and cavity tray system. It is supplied in 20m rolls and available in a wide-variety of widths. Unit Size: 225mm x 20m roll