Sika Waterproofing

A post applied self-adhesive waterproofing sheet membrane. It is based on a top layer of polyethylene film bonded to a layer of bitumen/polymer adhesive carried on a release paper, with a selvedge strip. Unit Size: 1.05m x 19.05m

A two-component, low odour, rapid curing, high solids, PUA/PU hybrid primer for consistent and durable adhesion of Sikalastic® Systems on cement based substrates. Unit Sizes: 11.5ltr (Part A=8.89ltr, Part B=2.61ltr)

Extra hard nails for use with the Trak-It C5 gas fixing tool. Unit Size: Sold per box, 700 in a box

A 150mm wide tape which has many uses but is mostly used to seal membrane from walls to floors and the channel system. Tacky on one side only, this can also be used to overtape external joints and used on floor oversealing. Unit Size: 150mm x 20m

.

.

A glass fibre mat reinforcement for Decothane and Sikalastic Liquid Applied Membrane Systems. Unit Size: Roll

A single component mastic consisting of polymer modified natural sodium bentonite and further polymer additives. Trowel applied and thixotropic in nature. Unit Size: 15ltr

Sika Bentoshield fixing washers are special plastic washers used to fix Sika Bentoshield membrane to vertical surfaces and horizontal laps. Unit Size:

Sika® Brick plugs are 10mm fixings to use with membrane systems, with the advantage of a rubber seal already attached. Unit Size: 200 per box

A rectangular acrylic sealing profile. It swells in contact with water to seal all types of construction joints and penetrations in concrete structures. Unit Size: 20mm x 5mm x 20m

A fully bonded, composite sheet membrane waterproofing system for reinforced concrete structures. It consists of an embossed polyolefin (FPO) based membrane laminated with a unique sealant and a non-woven fleece with a self-adhesive strip on the longitudinal side for the overlap. Unit Sizes: 1m x 30m

A self‐adhesive tape, based on a polyacrylate adhesive on a yellow carrier film coated with the SikaProof A fully bonded system. Unit Sizes: 150mm x 25m roll

A single-sided, self-adhesive tape based on SikaProof® membrane, laminated with a butyl adhesive covered with a release liner. Unit Size: 200mm x 20m

A high-density polyethylene, high capacity cavity drainage membrane. Unit Size: 2m x 20m long

The Sika Bentoshield Fixing Nose Piece is designed to support the washer on the end of the gun and hold it in place for safe and correct fixing of the Sika Bentoshield membrane system. Unit Size:

A 2 component polymer modified bituminous flexible thick coating extended with fibre for waterproofing against dampness and moisture ingress. Unit Size: 32kg (Part A-Liquid=24kg, Part B-Powder=8kg)

A two component, solvent free, highly elastic, low odour polyurea hybrid waterproofing membrane. Unit Size: 25kg (Part A= 9.2kg, Part B=15.8kg)

A flexible waterproofing tape based on modified flexible Polyolefin (FPO) with advanced adhesion properties. It has red masking tape on one side for easier application over expansion joits. Unit Size: 1 roll of 25m length Varying widths available: 10, 20, 30cm

A galvanised metal sheet with a special coating applied on one side to increase its adhesion to fresh concrete Unit Size: 15m rolls

A high density polyethylene (HDPE), heavy duty drainage and protection sheet with 10mm high dimples on the bottom layer and a bonded geotextile (PP) filtration layer on the top layer. Unit Size: 2,44m width x 12,50m length

An acrylic sealing ring profile. It swells in contact with water to seal spacer bars / tie bars / tie rods. Unit Size: Internal Diameter=18mm, External diameter=20mm

A polyolefin (FPO) based sheet membrane for below waterproofing of reinforced concrete structures. Unit Size: 1m x 25m roll

An acrylic sealing ring profile. It swells in contact with water to seal spacer bars / tie bars / tie rods. Unit Size: Internal Diameter=43mm, External diameter=45mm

An acrylic sealing ring profile. It swells in contact with water to seal spacer bars / tie bars / tie rods. Unit Size: Internal Diameter=26mm, External diameter=28mm